5. From the screen that displays, select the method the routine will use to remove the
unfused dry ink/toner:
• Clean with Paper - press prints blank sheets to remove the dry ink/toner from the
fuser
• Clean with Felt - press removes the dry ink / toner from the fuser by applying the
felt against the pressure roll (no paper is used)
6. If you selected the Clean with Paper option:
a) From Paper Supply, select the paper tray to use.
Note
Any type of paper and size can be used. However, the smooth surface of coated
paper does offer more contact area to the pressure roll.
b) From Number of Sheets, select the number of blank sheets to run (1 to 5).
Note
For best results, run a minimum of 5 sheets.
7. Select Save.
8. Press the Start button. The system begins the cleaning process and displays a
"successfully completed" message when finished. Select OK.
Note
The process with 5 sheets of paper will take approximately one minute.
Xerox
®
Versant
®
80 Press6-20
System Administration Guide
Setup and Calibration (Tools Administrator Mode)
To Next Page
Loading...
