Xerox Versant 80 Press - Page 48

Adjustments can be made when the position of the output image is misaligned or skewed.
This may be a result of paper expansion or contraction, cutting inaccuracy, or paper
storage conditions. To compensate for this scenario, the Manual Alignment Adjustment
feature can be used to adjust the image alignment.
The following adjustments can be made to the position of the output image.
• Squareness Adjustment (Skew): Adjust a skewed image
• Scale Adjustment: Adjust this when the size (scale) of the printed image is offset
• Print Position Adjustment: Use this option when making adjustments to the lead
edge of the image (X direction) and side edge of the image (Y direction). For example,
use this when the images on sides 1 and 2 are misaligned.
Manual Alignment Adjustment Procedure
Always perform the Auto Alignment Adjustment (SIQA chapter) procedure before doing
any manual adjustments.
1. Load paper in a tray.
2. Log in as the administrator.
3. Press the Machine Status button on the UI.
4. Select the Tools tab.
5. Select System Settings > Common Service Settings .
6. Select Maintenance.
7. Select Alignment Adjustment.
8. Select Manual Alignment Adjustment.
9. Select Alignment Adjustment Type Setup, and press Change Settings.
10. Select the alignment adjustment type you want to set or adjust, and press Change
Settings.
11. Select Name, and press Change Settings.
12. Assign a type name, and press Save.
Note
We recommend using a name such as "A4 Plain" that allows you to know what the
content of the paper type is.
13. Press Sample Printout.
14. Select the paper tray in which you loaded paper in Step 1, and then select 1-Sided
or 2-Sided followed by the desired number of sheets via the Number of Sheets option.
Note
When using the Squareness Adjustment option, select the A3 paper size. When using
the Number of Sheets option, we recommend printing about 10 sheets in order to
calculate the average value of the variations.
15. Press the Start button.
The current sample output is printed.
If the position of the sample output is correct, a line is printed at a position 10 mm
from the edge of the paper. If the position of the line on the sample output is
misaligned, make adjustments accordingly.
Xerox
®
Versant
®
80 Press4-18
System Administration Guide
System Settings (Tools Administrator Mode)