Consumables
Xerox
® WorkCentre® 3025
User Guide
170
Storage and Handling of Consumables
The print cartridge contains components that are sensitive to light, temperature, and humidity. Follow
the recommendations provided to ensure the optimum performance, highest quality, and longest life
from your new print cartridge.
Follow the guidelines below for storing and handling consumables:
• Always store print cartridges unopened and inside their original package.
• Store the correct side up in a horizontal position (not standing on end).
• Do not store consumables in:
• Temperatures greater than 40°C (104°F).
• Humidity range less than 20% and not greater than 80%.
• An environment with extreme changes in humidity or temperature.
• Direct sunlight or room light.
• Dusty places.
• A vehicle for a long period of time.
• An environment where corrosive gases are present.
• An environment with salty air.
• Do not store consumables directly on the floor.
• Do not touch the surface of the photosensitive drum in the print cartridge.
• Do not expose the print cartridge to unnecessary vibrations or shock.
• Never manually rotate the drum in the print cartridge, especially in the reverse direction; this can
cause internal damage and toner spillage.
When to Order Consumable Supplies
To avoid print quality problems resulting from worn parts and to maintain your
machine in top working condition, replace the print cartridge as directed:
•A blinking orange warning light and a message appear on the control panel
when the print cartridge is near its replacement time. Check that you have
replacements on hand, and order them when the warning appears if you do not. It
is important to order these items when the messages first appear to avoid interruptions to your
printing.
•An error message and a solid orange warning light appear on the control panel when the print
cartridge must be replaced.
To replace the print cartridge follow the instructions provided below or with the consumable.
WARNING: When replacing consumables, DO NOT remove the covers or guards that are fastened
with screws. You cannot maintain or service any of the parts that are behind these covers and
guards. Do NOT attempt any maintenance procedure that is NOT specifically described in the
documentation supplied with your machine.
To Next Page
Loading...
Need help?
General
