Loading Paper
Xerox® WorkCentre® 3025
User Guide
66
Loading Paper
Tray 1 is standard on your machine.
Various media sizes and types can be used in the tray. For more media specifications, refer to Media
Specifications.
Preparing Paper for Loading
Before loading paper into the tray, flex or fan the edges of the
paper stack. This procedure separates any sheets of paper
that are stuck together and reduces the possibility of paper
jams.
Note: To avoid unnecessary paper jams and misfeeds, do
not remove paper from its packaging until required.
Using Tray 1
Tray 1 is located on the front of your machine. It can be closed when not in use, making the product
more compact. Use the tray to print on standard media as well as transparencies, labels, envelopes or
postcards.
Use the manual mode for all special media.
Acceptable print media is plain paper from 3.0 x 5.0 inches to 8.5 x 14 inches Legal (76 mm x 127 mm
to 216 mm x 356 mm) and weighing between 16 lb and 43 lb (60 g/m² and 163 g/m²). For more media
specifications, refer to Media Specifications.
Loading Tray 1
1. Lower tray 1, located on the front of the machine.
2. Prepare a stack of paper for loading by flexing or fanning
it back and forth. Straighten the edges on a level surface.
Remove any curl on postcards, envelopes and labels
before loading them into the tray.
Note: In the automatic mode, the tray holds a maximum
of 150 sheets of 20 lb (80 g/m²) bond paper, 1
transparency sheet, or 1 envelope. In Manual Feeder
mode, selected on the Paper tab in the print driver, the
tray holds 1 sheet of all media types. Use of the manual
mode for special media is strongly recommended.
3. Load the print material between the width guides with
the print side facing up.
Note: Hold transparencies by the edges and avoid touching the print side.
To Next Page
Loading...
Need help?
General
