Fax Regulations
Xerox® WorkCentre® 3025
User Guide
234
4. This device is equipped with pulse dialing, while the Telecom standard is DTMF tone dialing. There
is no guarantee that Telecom lines will always continue to support pulse dialing.
5. Use of pulse dialing, when this equipment is connected to the same line as other equipment, may
give rise to bell tinkle, or noise, and cause a false answer condition. If you encounter such
problems, do not contact the Telecom Faults Service.
6. DTMF tone dialing is the preferred method because it is faster than pulse (decadic) dialing and is
readily available on almost all New Zealand telephone exchanges.
WARNING: No ‘111’ or other calls can be made from this device during a mains power failure.
7. This equipment may not provide for the effective hand-over of a call to another device connected
to the same line.
8. Some parameters required for compliance with Telecom Telepermit requirements are dependent
on the equipment (computer) associated with this device. The associated equipment shall be set
to operate within the following limits for compliance with Telecom Specifications:
For repeat calls to the same number:
• There shall be no more than 10 call attempts to the same number within any 30 minute
period for any single manual call initiation, and
• The equipment shall go on-hook for a period of not less than 30 seconds between the end of
one attempt and the beginning of the next attempt.
For automatic calls to different numbers:
The equipment shall be set to ensure that automatic calls to different numbers are spaced such
that there are no less than five seconds between the end of one call attempt and the beginning of
another.
9. For correct operation, total of the RENs of all devices connected to a single line at any time should
not exceed five.
To Next Page
Loading...
Need help?
General
