Xerox WorkCentre M15 - System Setup Options

Page 9-12 Xerox WorkCentre M15/M15i User Guide
Machine Administration
System Setup Options
OPTION SETTINGS DESCRIPTION
Receive Mode
l Use to set the receive
mode, depending on how
the machine is connected
to the telephone line.
TEL Use to operate in manual mode. When a call is
received pick up the external phone handset or press
[Manual Dial]. If a fax tone can be heard, press [Start]
and replace the handset.
FAX The machine answers the incoming call and
immediately switches to fax receive mode.
TEL/FAX The machine answers the incoming call. If a fax tone
is not detected, the machine sounds a ringing tone to
indicate a voice phone call. To answer the call, press
[Start] on the control panel, then lift the handset. If the
external phone is not lifted while the ringing tone is
sounding, the machine will switch to automatic fax
reception mode.
ANS/FAX Use if attaching an answering machine to the
WorkCentre M15/M15i. If the machine detects a fax
tone, it switches to fax mode automatically.
Secure Receive
l Use to store all received
faxes in the machine’s
memory until printed by a
user.
ON Use to receive all faxes into the machine’s memory.
When enabling Secure Receive a secure passcode
can be entered to restrict access to the faxes
received. If a passcode has been setup, when
PRINT is selected the passcode is required.
OFF
PRINT
Prefix Dial Fax No.
l Use to set a prefix dial
number.
Up to 5 digits The number entered will be added to the beginning of
each fax sent.
Ringer Volume
l Use to set the ringer
volume level.
10 Levels To switch the ringer off, set to the left. Set to the right
for a loud ring tone.
Alarm Sound
l An alarm tone will sound
when an error occurs or a
fax communication ends.
ON Set to ON to enable an alarm sound.
OFF
Key Sound
l A key tone sounds each
time any key is pressed.
ON Set to ON to enable a key sound.
OFF