9
subject to excessive dust or iron powder in the air.
2-2-3．Orientation
Install the servo driver perpendicular to the wall as shown in the figure. The servo driver
must be oriented this way because it is designed to be cooled by natural convection or by a
cooling fan.
2-2-4．Installation
Follow the procedure below to install multiple servo drivers side by side in a control
panel.
Servo Driver Orientation
Install the servo driver perpendicular to the wall so the front panel containing connectors
faces outward.
Cooling
As shown in the figure above, allow sufficient space around each servo driver for cooling
by cooling fans or natural convection.
Side-by-side Installation
To Next Page
Loading...
