24
4 Use the operate panel
This chapter describes the basic operation of the operate panel and the features it offers.
All parameter settings and motor operations can be executed by simple, convenient
operations.
4-1．Basic Operation
This section provides information on the basic operation of the operate panel for setting
operating conditions.
4-1-1. Functions of operate panel
The operate panel can be used for parameter settings, operating references, and status
displays.
5-bit LED: Displaying parameter settings, status or alarm.
Power LED POWER: The LED is on when the servo driver is powered on.
Charge LED CHARGE: The LED is on when the main circiut is powered on. When
the power of main circiut is off, electric charges remain in the capacitors, and at this
time DO NOT touch the servo.
This section provides information on the keys and their functions available from the initial
displays.
Press: Status switch, status return
rease the value; Press and hold: Increase the value continuously
Press: Decrease the value; Press and hold: Decrease the value continuously
Press: Shift the editing digit; Press and hold: Enter a status, Enter
4-1-2. Basic Mode Switching
The operate panel can display the status, set parameter and run the command by switching
the basic mode.
The running status, auxiliary function, parameter setting, and monitoring are the basic
modes. The modes switch as the below diagram by pressing STATUS/ESC.
To Next Page
Loading...
