Wi-Fi Array
132 Viewing Status on the Wi-Fi Array
static IP address. To enable DHCP or to assign a static IP address for the
Array, go to “Express Setup” on page 173.
Location: The location assigned to the Array. To establish the location
information, go to “Express Setup” on page 173.
Array OS: The software version running on the Array.
IAP: The number of IAPs on the Array.
(IAP) Up: Informs you how many IAPs are currently up and running. To
enable or disable all IAPs, go to “Express Setup” on page 173. To enable
or disable individual IAPs, go to “IAP Settings” on page 271.
SSID: Informs you how many SSIDs have been assigned for the Array. To
assign an SSID, go to “SSID Management” on page 248.
(SSID) On: Informs you how many SSIDs are enabled. To enable or
disable SSIDs, go to “SSID Management” on page 248.
In Range: Informs you whether the Array is within wireless range of
another Wi-Fi Array.
Fast Roam: Informs you whether or not the Xirrus fast roaming feature is
enabled. This feature utilizes the Xirrus Roaming Protocol (XRP) ensuring
fast and seamless roaming capabilities between IAPs or Arrays at both
Layer 2 and Layer 3. To enable or disable fast roaming, go to “Global
Settings (IAP)” on page 277.
Uptime (D:H:M): Informs you how long the Array has been up and
running (in Days, Hours and Minutes).
To see additional information, select from the following checkboxes at the bottom
of the page. This will show the columns described below.
Hardware
Model: The model number of each Array (XN16, XS4, etc.), plus the
amount of RAM memory and the speed of the processor.
Serial: Displays the serial number of each Array.
License
License Key: The license key of each Array.
To Next Page
Loading...
Need help?
General
