Wi-Fi Array
94 Installing the Wi-Fi Array
Installation Workflow
This workflow illustrates the steps that are required to install and configure your
Wi-Fi Array successfully. Review this flowchart before attempting to install the
unit on a customer’s network.
Figure 35. Installation Workflow
See Also
Coverage and Capacity Planning
Deployment Examples
Determine the number of Arrays needed
Choose the location(s) for your Wi-Fi Arrays
Install the mounting plate
Connect the cables and turn on the power
Verify that the Ethernet link and radio LEDs are functioning correctly
Perform the Express Setup procedure
Run Ethernet cables for PoGE
(<100m total distance from switch)
Log in to WMI and enter your license
To Next Page
Loading...