Doc. 20780_03 61
DPRO Passive-Infrared (PIR) PRO Series by Xtralis Planning and Commissioning Manual
2. Click ( ), the following field appears:
3. Enter file name,
4. Click (OK) to save, or (Abort) to cancel the action.
10.3.4.2.7 Load Settings from CFG File
To load the configuration saved in a CFG file, follow these steps:
1. Click ( ), the following window appears:
2. Select the file,
3. Click (Open), the configuration appears in the Settings window so you can make sure
you are using the desired configuration.
4. Click ( ) to upload settings to detector.
10.3.4.3 Com Port
For more information on how to select the port you want to use, refer to section (10.3.2
Select Communication Port).
10.3.4.4 Language
The Software provides the settings and parameters in various languages displayed in this
menu.
To switch between the available languages, follow these steps:
1. Click “Language”,
2. Select the language you want.
Parameters and settings are now displayed in the selected language, but as for the interface
language itself it is only available in English.
10.3.4.5 Beep
To Next Page
Loading...
Need help?
General
