Xtralis VESDA-E VEP-A10-P User Manual

VESDA-EVEP-A10-P Product Guide
www.xtralis.com 51
2. Enter a unique name for the Connection or accept the pre-generated name, then select Finish
(Figure5-4).
Figure5-4: Enter a Connection Name
Adding an Ethernet or WiFi connection
1. Select Ethernet / WiFi, then select Next (Figure5-5).
Figure5-5: Select Ethernet
2. Enter the IPaddress of the detector. Enter the password that has been set for Ethernet and WiFi
authentication. Select Next (Figure5-6).
Note: The IP address and password of the detector is configured in the Ethernet or WiFi options
section during initial setup with a USB connection. Refer to Section 5.5.3 on page 61 or 5.5.4
on page 63 for further information.
Figure5-6: Enter IPAddress

Xtralis VESDA-E VEP-A10-P Specifications

General

Brand	Xtralis
Model	VESDA-E VEP-A10-P
Category	Smoke Alarm
Language	English