Yamaha DSP-A2 Owner's Manual

44
Notes
●
Once the output level is adjusted, the level value will be the
same in all the digital sound field programs.
●
The value of each speaker output level you set the last time
will remain memorized even when this unit is in the standby
mode.
However, if the power cord is disconnected for more than
one week, these values will be automatically changed to the
factory default settings.
●
If the function “1A. CENTER SP” in the SET MENU mode is
set in the “NONE” position, the center speaker output level
cannot be adjusted. This is because, in this mode, the
center sound is automatically output from the left and right
main speakers.
●
When one of the DSP programs No. 1 to 7 is selected, the
center speaker output level cannot be adjusted.
●
When is not illuminated on the display, the
front effect speaker output level cannot be adjusted.
DSP
BASIC OPERATION
Speakers
CENTER
RIGHT SURROUND (R SUR.)
LEFT SURROUND (L SUR.)
FRONT
SUBWOOFER (SWFR)
Preset value
0
0
0
0
0
Control range (dB)
MIN, –20 to +10
MIN, –20 to +10
MIN, –20 to +10
MIN, –20 to +10
MIN, –20 to 0

Yamaha DSP-A2 Specifications

General

Frequency Response	20Hz - 20kHz
Total Harmonic Distortion	0.015%
Type	AV Amplifier
Input Sensitivity	200 mV (Line)
Channel Separation	60 dB
Speaker Load Impedance	4-16 ohms
Video Connections	Composite, S-Video
Surround Sound Formats	Dolby Digital, DTS
Signal-to-Noise Ratio	100 dB
Dimensions	435 x 171 x 476 mm
Damping Factor	80 (8 ohms, 1kHz)
Digital Inputs	2 Coaxial
DSP Modes	Cinema DSP
Inputs	Phono
Outputs	Speaker Outputs