Yamaha RTX810 - Page 143

143
Troubleshooting
8
Symptom ▶ Cause ▶ Remedy
Unable to display the
“Basic configuration
page”. (Continued
from the previous
page)
The PC is controlled remotely via
Web browser.
• If the access restriction function through
IP address is enabled, when an access is
attempted from an unauthorized host, the
message
“Error 503 This server is available to
members only. I'm sorry, your host is
not member.” is displayed. To remotely
control the PC, change the setting of
“Hosts permitted to use HTTP” (page 100).
The “Basic
configuration page”
does not appear
after entering the
password.
The password is not correct.
(The password error is displayed.)
• For password, the system distinguishes
between single-byte and double-byte
characters and between upper and lower
cases. Always enter the password using
single-byte characters and be aware of
case sensitivity.
• If authentication information (user name,
password) remains in the Web browser,
such information will be sent and an
error may result. Delete the user name
before entering the password, or close
the Web browser and reopen the “Basic
configuration page”.
The login password was entered.
(The administration password
should be used here.)
If password has been set, enter the
administration password.
The setting is
returned to the
original state.
You did not click “Submit” after
configuration.
If you have changed the setting in the “Basic
configuration page”, you must click “Submit”
to save the setting. If you fail to click “Submit”
but click “Return to top” or close the window,
the setting will not be saved.
You have entered an invalid
value or one that is outside the
allowable range.
Enter a correct value.
The password
cannot be saved in
the Web browser
when opening the
“Basic configuration
page”.
The “User name” field is empty in
the screen prompting you to enter
the user name and password.
Some Web browsers require user name
entry to save password. In this case, enter
an arbitrary character string.