Yamaha RTX810 - Communication Charges of the USB Data; Communication Terminal Is Abnormal

155
Troubleshooting
8
Communication charges of the USB data
communication terminal is abnormal
Check the provider setting
Even if the USB data communication terminal contract is a
at-rate system any use of it with an incorrect conguration
could be charged for under the measured-rate system. In the
“Basic conguration page”, click “Advanced settings ” -
“Detailed basic connection setting”. In the “Modify provider”
screen, check that the setting is correct.
Check the communication
history
If the Internet connection is made by the auto-connect
function, Internet connection may be made automatically
by software or a device of the PC. Also, certain types
of software are activated automatically while the PC is
starting. In this case, outgoing calls may be generated
automatically without the user's knowledge. If the USB
data communication terminal contract is the measured-rate
system, you may be charged substantial fees. To prevent
this, check the communication history frequently.
Be especially careful when you:
• start using the product;
• change any provider connection settings of the product;
• change the dial network setting of the PC;
• install new software on your PC;
• connect to the network with a new PC, network
equipment, or peripheral equipment;
• update the rmware of the product; or
• perform any different operations than usual or sense a
difference in the communication response.
Note
• After cancelling or changing your provider contract please be
sure to delete or recongure the connection conguration of
the product. Failure to observe this could result in unexpected
charges from your telephone carrier or provider.
• Unexpected communication charges could occur according
to the status (change in access point, maintenance, error, etc.)
of the provider side. Please be sure to pay constant attention
to any notications you receive from your provider.
• The screen and settings used here may vary by software
version.