Transportation
3 - 25
3.1.2 Using a forklift
If the robot controller is to be transported by forklift, it must be secured with safety belts, as
shown in the figure "Transport by forklift" below. Make sure that the forklift and the
transportation route have sufficient bearing capacity.
Always take due care when transporting the robot controller.
Fig. 3-2: Using a forklift
3.1.3 Using a lifting truck
By removing the lower front cover you will access to a tunnel under the cabinet. Normally
cables are led through this opening. However, it can also be used to lift the control cabinet.
1. Remove the lower front cover by grabbing it at left and right side.
2. Pull it straight out.
Fig. 3-3: Using a lifting truck
Protective padding Palette
Tiedown straps Forklift tines
1
2
3
4
1
3
2
4
To Next Page
Loading...
