1INTRODUCTION
18
1.4 Installing Job EditorDX200
1. It is strongly recommended that you exit all applications before running the setup
program.
2. Insert the installation CD into the CD-ROM drive. When the [User Account Control]
dialog appears automatically, click [Yes]. [Job EditorDX200 - InstallShield Wizard] will
be displayed.
3. Follow the on-screen instructions.
4. When the setup is completed, Job EditorDX200 is registered under the {Job
EditorDX200} folder that appears by clicking the [Start] button in the task bar and
selecting {Program} and then {Motoman}. (In the case of Windows10, all menu
appears directly under [Motoman].)
5. Connect the hardware key to the printer port or USB port.
For details, refer to section 1.3 "Hardware Lock Key" in this chapter.
Be sure to login in administrator mode when installing the Job EditorDX200, or
else the system related DLL files in Windows might not be updated.
If the following message appears during the installation, press [Yes] to continue
installation.
This message is displayed when the installation of redistribution package of Visual
C ++ 2012 has been executed but installation is required.
If this message is displayed, run manually
\ISSetupPrerequisites\{BF2F04CD-3D1F-444e-8960-
D08EBD285C3F}\vcredist_x86.exe after installing Job EditorDX200, and install or
repair the redistribution package of Visual C ++ 2012.
To Next Page
Loading...
