YASKAWA DX200 - Selecting Options When Creating a Job

2BASIC OPERATION
27
HW1482392
 Selecting Options when Creating a Job
Job Type
Select whether a job including position data is to be created.
"Robot" contains position data, and "Non Robot" contains no position data.
Control Group
Select the job control group. If the control group is not found in this list, register the control
group in the "Group Combination Registry," and re-open this window.
(Refer to section 5.1 "Defining Control Groups" for details on defining control groups.)
Job Folder Name
Select the job folder name. Or, enter the new job folder name using lower-case letters,
maximum 32 characters.
A file is created in the folder. If any existing job has the same name, the following
message appears. Select [Yes] only when the existing job is to be overwritten.
NOTE