YASKAWA DX200 - Page 80

4EDITING (TEXT)
81
HW1482392
In the text mode, There are the following restrictions.
• Job header part is not be automatically corrected. If move instruction or aliases is
modified, the header part needs to be modified in the manual.
• Macro instruction does not appear in the macro job name.
• There are restrictions on the input support function.
• Input Support is case-sensitive.
• The candidates display demends on the language level.
• ON/OFF and CONTANT is not displayed.
• About the structured language, the candidates of the conditional statement
and the candidates (AND or OR) after the conditional statement is not
available.
• The displayed format is the text data saved in ex. memory. So, WHILE,
IFTHEN, AND and Or are displayed as WHILEEXP, IFTHENEXP, ANDEXP
and OREXP.
• The candidates after the EXPRESS of SET instruction is not available.
• The candidates of macro instruction is not available.
• The candidates of aliases is not available.
When clicking [Text], the following dialog appears sometimes.
When clicking [Yes], the file is saved and shift to Text mode.
When clicking [No], the file is not saved and shift to Text mode.
When clicking [Cancel], mode shift is canceled.
If there is a temporary file that has been saved in the previous text mode, the
following dialog appears.
When clicking [Yes], the temporary file is opened instead of the current job file and
shift to Text mode.
When clicking [No], the current is opened and shift to Text mode.
The temporary file is automatically deleted when the job file has been successfully
saved in text mode.
NOTE