User Guide for CP960 IP Phone
140
Placing Calls
You can place calls on the IP phone in numerous ways, including placing calls by dialing, placing
calls from call history or placing calls to contacts. If you connect a mobile phone to your IP
phone, you can also place calls over Bluetooth.
For more information, refer to Contact Management on page 83, Connecting a Mobile Phone
Using Bluetooth on page 227 and Call History Management on page 100.
Placing a Call
To place a call:
1. Tap .
2. Enter the desired number using the onscreen dial pad.
Tap to see the onscreen keyboard, and then you can enter the number using the
onscreen keyboard.
3. Tap Send.
Note
You can also dial using the SIP URI or IP address. To obtain the IP address of a phone, tap
Settings and then tap General from the Status block. The maximum SIP URI or IPv4 address
length is 32 characters. For example, SIP URI: 3606@sip.com, IP: 192.168.1.15.
Your phone may not support direct IP dialing. Contact your system administrator for more
To Next Page
Loading...
