Yealink CP960 - Call Waiting

User Guide for CP960 IP Phone
162
- Tap , and then select the desired list. Tap the desired entry to dial out.
3. Tap Transfer to complete the transfer when receiving ringback.
Attended Transfer
Before performing an attended transfer (except you use dial number method), make sure that
the transfer mode via Dsskey is configured as New Call or Attended Transfer. For more
information on how to configure it, refer to Configuring Transfer Mode via DssKey on page 183.
To perform an attended transfer:
1. Tap More->Transfer during a call.
2. Do one of the following:
- Enter the number you want to transfer the call to.
Tap Transfer. The phone will prompt a dialog box. Tap Send to dial out. (The call will
automatically dial out in about 5 seconds if you do not tap Send.)
- Tap . Search for the contact and tap the desired contact and tap the desired
contact to dial out.
- Tap , and then tap -> Remote Phone Book. Search for the contact
and tap the desired contact to dial out. (Remote phone book should be configured in
advance, refer to Remote Phone Book on page 98 for more information.)
- Tap , and then select the desired list. Tap the desired entry to dial out.
3. After the party answers the call, tap Transfer to complete the transfer.
Call Waiting
You can enable or disable call waiting on the phone. If call waiting is enabled, you can receive
another call when there is already an active call on the phone. Otherwise, another incoming call
is automatically rejected by the phone with a busy message when there is an active call on the
phone. You can also enable or disable the phone to play a warning tone when receiving another
call.
To configure call waiting via phone user interface:
1. Tap Settings from the Home screen.
2. Tap Call Waiting from the Features block.
3. Turn on Call Waiting.
4. Turn on Play Tone.