Yealink CP960 - Turning the CPW90 On or Off

User Guide for CP960 IP Phone
244
Turning the CPW90 On or Off
To turn on the CPW90, do the following:
- Put the CPW90 on a charging cradle, the CPW90 starts up automatically.
- If you do not charge the CPW90, long tap on the CPW90 for 3 seconds.
The battery indicator LED illuminates solid green for one second and then goes out.
To turn off the CPW90:
1. Long tap on the CPW90 until the battery indicator LED on the CPW90 illuminates
solid red for 3 seconds and then goes out.
Registering/Unregistering the CPW90
The Yealink CPW90 is a CP Wireless Expansion Mic which works as an audio input device for
CP960 IP phone. It features superior audio technology and supports 360-degree voice pickup
range at a radius of up to 10 feet (3 meters) without any wiring troubles.
To ensure good voice quality of the calls on the IP phone, you can register CPW90 with the IP
phone to use the CPW90 as the external audio input device.
Note
CPW90 can only be registered with one IP phone at a time, if you register the CPW90 to another
IP phone, the CPW90 will deregister from the previous IP phone automatically.
To register the CPW90 with the IP phone:
1. Do the following on the IP phone:
Tap Settings from Home screen.
Tap Wireless Microphone from Basic block.
If you buy CP960-WirelessMic, the CPW90 is registered with the IP phone by default.