Yealink CP960 - Page 205

Advanced Phone Features
205
The following figure shows a multicast RTP session on the phone:
2. Your can do the following:
 Tap More->Hold to place the current multicast RTP session on hold.
The sender’s phone places the multicast RTP session on hold and receiver’s phone
releases the session.
To resume the held multicast RTP session, tap or tap More->Resume.
The multicast RTP session is established again.
 Tap DND to enable or disable DND mode.
 Tap Mute to mute the multicast RTP session, all other participants can hear each
other, but they cannot hear you.
 Tap EndCall to cancel the multicast RTP session.
 Tap to record a call.
To stop recording, tap .
Note
To send RTP stream via a paging key list when the receiver’s phone is idle:
1. Tap paging list key from the DSS key screen.
2. Do one of the following to send RTP:
- Tap the desired paging group.
- Tap after the desired paging group, and then tap Multicast Paging.
Multicast RTP is one way only from the sender to the multicast address(es) (receiver). For
outgoing RTP multicasts, all other existing calls on the phone will be placed on hold.