Yealink SIP-T43U Administrator's Guide

Administrator’s Guide for SIP-T2 Series/T4 Series/T5 Series/CP920 IP Phones
115
Description
It configures whether to use audio encryption service.
Permitted
Values
0-Disabled
1-Optional, the phone will negotiate with the other phone what type of encryption to use for the ses-
sion.
2-Compulsory, the phone must use SRTP during a call.
Default
0
Web UI
Account > Advanced > RTP Encryption (SRTP)
Parameter
account.X.srtp_lifetime
[1]
<MAC>.cfg
Description
It configures the lifetime of the master key used for the cryptographic parameter in SDP. The value spe-
cified is the number of SRTP packets.
When the lifetime is set, a re-invite with a new key is sent when the number of SRTP packets sent for
an outgoing call exceeds half the value of the master key lifetime.
Note: Setting this parameter to a non-zero value may affect the performance of the phone. It works
only if “account.X.srtp_encryption” is set to 1 (Optional) or 2 (Compulsory).
Permitted
Values
Integer greater than or equal to 0
0-the master key lifetime is not set.
1 to 1024-the master key lifetime is 1024.
1025 to 2^48-the master key lifetime is the configured value.
A value greater than 2^48-the master key lifetime is 2^48.
Default
0
Parameter
account.X.srtp.unencrypted_rtp.enable
[1]
<MAC>.cfg
Description
It enables or disables the phone’s capability to include unencrypted RTP streams in SDP offers when
using SRTP.
Note: It works only if “account.X.srtp_encryption” is set to 1 (Optional) or 2 (Compulsory).
Permitted
Values
0-Disabled
1-Enabled, the phone offers both encrypted and unencrypted RTP streams (Unencrypted RTP
streams carry UNENCRYPTED_SRTP session parameters) in SDP offers. After a successful nego-
tiation, whether the RTP stream is encrypted or not depends on the SDP answer.
Default
0
Parameter
account.X.srtp.unencrypted_rtcp.enable
[1]
<MAC>.cfg
Description
It enables or disables the phone’s capability to include unencrypted RTCP streams in SDP offers
when using SRTP.
Note: It works only if “account.X.srtp_encryption” is set to 1 (Optional) or 2 (Compulsory).
Permitted
Values
0-Disabled
1-Enabled, the phone offers both encrypted and unencrypted RTCP streams (Unencrypted RTCP
streams carry UNENCRYPTED_SRTCP session parameters) in SDP offers. After a successful nego-
tiation, whether the RTCP stream is encrypted or not depends on the SDP answer.
Default
0

Yealink SIP-T43U Specifications

General

Mounting	Desk/Wall
Handset type	Wired handset
Product type	IP Phone
Product color	Gray
Wall mountable	Yes
Sustainability certificates	REACH, RoHS
AC adapter input voltage	100 - 240 V
AC adapter output current	1.2 A
AC adapter output voltage	5 V
Power consumption (typical)	2.2 W
Bluetooth version	4.1
Networking standards	IEEE 802.1Q, IEEE 802.1p, IEEE 802.1x, IEEE 802.3af
Ethernet LAN data rates	10, 100, 1000 Mbit/s
Ethernet LAN interface type	Gigabit Ethernet
Supported network protocols	FTP/TFTP/HTTP/HTTPS, IPv6, LLDP/CDP/DHCP VLAN
USB 2.0 ports quantity	2
Lines quantity	12 lines
Phonebook capacity	1000 entries
Number of VoIP accounts	12
Voice codecs	AGC, AJB, AMR-NB, AMR-WB, G.711Mu, G.711a, G.723.1, G.726, G.729ab, OPUS, PLC, VAD, iLBC
Number of handles included	1 pc(s)
Operating temperature (T-T)	-10 - 50 °C
Operating relative humidity (H-H)	10 - 95 %
Display diagonal	3.7 \
Display resolution	360 x 160 pixels
Dual-Tone Multi-Frequency (DTMF) modes	In-band, Out-of band, SIP info
Harmonized System (HS) code	85171800

Weight and Dimensions

Depth	206.2 mm
Width	224.9 mm
Height	174.9 mm
Package depth	223 mm
Package width	246 mm
Package height	120 mm