Yealink SIP-T43U Administrator's Guide

Phone Customization
247
Default
1
Web UI
Features > Notification Popups > Display Forward Call Popup
Parameter
features.text_message_popup.enable <y0000000000xx>.cfg
Description
It enables or disables the phone to pop up the message when it receives a new text message.
Note: It works only if “features.text_message.enable” is set to 1.
Permitted
Values
0-Disabled
1-Enabled
Default
1
Supported
Devices
All phones except CP920
Web UI
Features > Notification Popups > Display Text Message Popup
Power LED Indicator
Power LED indicator indicates power status and phone status. It is not applicable to CP920 phones.
You can configure the power LED indicator behavior in the following scenarios:
l The IP phone receives an incoming call
l The IP phone receives a voice mail or a text message
l A call is muted
l A call is placed on hold or is held
l The IP phone is busy
l The IP phone misses a call
Topic
Power LED Indicator Configuration
Power LED Indicator Configuration
The following table lists the parameters you can use to configure the power LED indicator.
Parameter
phone_setting.common_power_led_enable <y0000000000xx>.cfg
Description
It enables or disables the power LED indicator to be turned on.
Permitted
Values
0-Disabled (power LED indicator is off)
1-Enabled (power LED indicator glows red)
For T19(P) E2 phones:
0-Disabled (power LED indicator is off)
1-Enabled (power LED indicator glows yellow)
Default
0
Supported
Devices
All phones except CP920
Web UI
Features > Power LED > Common Power Light On
Parameter
phone_setting.ring_power_led_flash_enable <y0000000000xx>.cfg

Yealink SIP-T43U Specifications

General

Mounting	Desk/Wall
Handset type	Wired handset
Product type	IP Phone
Product color	Gray
Wall mountable	Yes
Sustainability certificates	REACH, RoHS
AC adapter input voltage	100 - 240 V
AC adapter output current	1.2 A
AC adapter output voltage	5 V
Power consumption (typical)	2.2 W
Bluetooth version	4.1
Networking standards	IEEE 802.1Q, IEEE 802.1p, IEEE 802.1x, IEEE 802.3af
Ethernet LAN data rates	10, 100, 1000 Mbit/s
Ethernet LAN interface type	Gigabit Ethernet
Supported network protocols	FTP/TFTP/HTTP/HTTPS, IPv6, LLDP/CDP/DHCP VLAN
USB 2.0 ports quantity	2
Lines quantity	12 lines
Phonebook capacity	1000 entries
Number of VoIP accounts	12
Voice codecs	AGC, AJB, AMR-NB, AMR-WB, G.711Mu, G.711a, G.723.1, G.726, G.729ab, OPUS, PLC, VAD, iLBC
Number of handles included	1 pc(s)
Operating temperature (T-T)	-10 - 50 °C
Operating relative humidity (H-H)	10 - 95 %
Display diagonal	3.7 \
Display resolution	360 x 160 pixels
Dual-Tone Multi-Frequency (DTMF) modes	In-band, Out-of band, SIP info
Harmonized System (HS) code	85171800

Weight and Dimensions

Depth	206.2 mm
Width	224.9 mm
Height	174.9 mm
Package depth	223 mm
Package width	246 mm
Package height	120 mm