Yealink VC110 - Call Type

Configuring Call Preferences
113
4. Select the desired codec from the Enable Codecs column, and click or to
adjust the priority of the selected codecs.
5. Click Confirm to accept the change.
The endpoint supports SIP and H.323 protocols for incoming and outgoing calls. H.323 is
commonly used to communicate to other video conferencing endpoints. SIP is
commonly used to communicate with other VoIP devices. The default call type on the
endpoint is Auto, and the endpoint preferentially uses the H.323 protocol to place calls.
If there is no available H.323 account on the endpoint, the endpoint will switch to the SIP
protocol for placing calls. You can specify the desired protocol for the endpoint to place
calls. Ensure that the remote endpoint supports the same protocol.
The call type parameter on the endpoint is described below:
Parameter
Description
Configuration Method
Call Type
Specifies the desired call type for
placing calls.
 Auto—the endpoint
automatically uses the
available call type.
 SIP—the endpoint uses the
SIP protocol for placing
calls.
 H.323—the endpoint uses
H.323 protocol for placing
calls.
Default: Auto
Remote Control
Web User Interface