Configuring Call Preferences
121
3. Select the desired value from the pull-down list of Downlink Bandwidth.
4. Click Confirm to accept the change.
To configure bandwidth via the remote control:
1. Select Menu->Call Features->Bandwidth Settings.
2. Select the desired value from the pull-down list of Uplink Bandwidth.
3. Select the desired value from the pull-down list of Downlink Bandwidth.
4. Press the Save soft key to accept the change.
You can configure video size mode for the VC110 video conferencing endpoint
according to current network environment.
The video size mode parameters on the endpoint are described below:
Selects the video size mode
automatically.
If the other party is Yealink
endpoint, then the endpoint will
send and receive 1080p30 video.
If the other party is not Yealink
endpoint, then the endpoint will
send and receive 720p30 video.
Remote Control
Web User Interface
To Next Page
Loading...
