Yealink VC110 - Far-End Camera Control

Administrator‘s Guide for Yealink VC110 Video Conferencing Endpoint
152
Far control of the near camera parameters are described below.
Parameter
Description
Configuration Method
Far Control Near
Camera
Enables or disables the far site to
control the near site camera.
Default: Enabled
Remote Control
Web User Interface
Far Set of Camera
Presets
Enables or disables the far site to
store the camera presets.
Default: Disabled
Remote Control
Web User Interface
Far Move to
Camera Presets
Enables or disables the far site to
use the camera presets.
Default: Disabled
Remote Control
Web User Interface
To configure far-end camera control via the web user interface:
1. Click on Setting->Video & Audio.
2. Select the desired values from the pull-down lists.
3. Click Confirm to accept the change.
To configure far-end camera control via the remote control:
1. Select Menu->Video & Audio->Far-end Camera Control.
2. Make the desired changes.
3. Press the Save soft key to accept the change.