Yealink VC110 - Configuring Endpoint Settings; General Settings

Configuring Endpoint Settings
125
This chapter provides information for making configuration changes for the endpoint,
such as language, time and date, backlight of the VCP40 video conferencing phone,
vido&audio settings and camera settings:
Topics include:
 General Settings
 Audio Settings
 Adjusting MTU of Video Packets
 Dual-Stream Protocol
 Mix Sending
 Configuring Camera Settings
 Far-end Camera Control
 Camera Control Protocol
 Tones
When the endpoint is idle, the site name is displayed on the status bar of display device
and VCP40 phone. When H.323 or SIP protocol is enabled, you can make an IP address
call to the far site, the site name will be displayed on the display device of the far site.
Site name can consist of letters, numbers or special characters. You can configure the
site name of the endpoint via the remote control or web user interface.
The site name parameter is described below:
Parameter
Description
Configuration Method
Site Name
Configures the site name of the
endpoint.
Valid values: String within 64
characters
Default: Yealink VC110
Remote Control
Web User Interface