Yealink VC110 - Camera Control Protocol

Configuring Endpoint Settings
153
VC110 video conferencing endpoints support camera control protocols: FECC (Far End
Camera Control). You can enable the FECC protocol for SIP call or H.323 call.
If far site wants to control the local camera, both the far site and near site should enable
the camera control protocol simultaneously. If the FECC protocol is not enabled on either
site, far-end camera control feature cannot be performed. For example, a SIP call is
established between two sites, the two sites must enable FECC (SIP) protocol
simultaneously to perform far-end camera control feature. If FECC (SIP) protocol and
FECC (H.323) protocol are both enabled, the endpoint will select the appropriate
camera control protocol according to the protocol (SIP or H.323) the call uses.
Camera control protocol parameters are described below:
Parameter
Description
Configuration Method
FECC(H.323)
Enables or disables the FECC
(H.323) protocol for far site to
control near camera.
Default: Enabled
Web User Interface
FECC(SIP)
Enables or disables the FECC
(SIP) protocol for far site to
control near camera.
Default: Disabled
Web User Interface
To configure camera control protocol via the web user interface:
1. Click on Setting->Video & Audio.
2. Select the desired value from the pull-down list of FECC(H.323).