Yealink VC110 - Configuring Security Features; User Mode; Administrator Password; Web Server Type

Configuring Security Features
173
This chapter provides information for making configuration changes for the following
security-related features:
 User Mode
 Administrator Password
 Web Server Type
 Transport Layer Security
 Secure Real-Time Transport Protocol
 H.235
 Attack Defense in Public Network
Users can access the endpoint menus directly (except the ―Advanced‖ menu) on the
display device. The ―Advanced‖ menu requires administrator credentials. You can
enable the user mode to provide two levels of access for the menus. You need to
configure a password for the user when the user mode is enabled. Users are prompted
to enter the password when accessing the menus (except the ―Status‖ menu). After the
user mode is enabled, the user can l log into the web user interface of the endpoint with
user credentials. The default user name is ―user‖.
User mode parameters on the endpoint are described below:
Parameter
Description
Configuration Method
User Type
Specifies the user type.
Default: Administrator
Note: To enable the user type,
you need to select User for this
parameter.
Web User Interface
User Mode
Enables or disables the user
mode.
Default: Disabled
Note: It is only applicable to the
user mode. The administrator
mode is enabled by default.
Web User Interface
User Password
Configures a password for the
Web User Interface