Yealink VC110 - VCM30 Video Conferencing Microphone Array; VCR10 Remote Control

VC110 Video Conferencing Endpoint Introduction
7
 VCM30 Video Conferencing Microphone Array
 Ethernet Cable (7.5m)
Locate the Audio In port of the cable hub, and connect it to the Audio Out port of the
VCM30 with the 7.5m Ethernet cable. VCM30 video conferencing microphone array can
work as the audio input device for the VC110 endpoint. For more information, refer to
Audio Input Device on page140.
Note
Before installing and using the VC110 video conferencing endpoint, you need to be
familiar with the following endpoint components, including:
 VC110 All-in-one Unit
 Cable Hub
 VCM60 Video Conferencing Wireless Microphone
 VCP40 Video Conferencing Phone
 VCM30 Video Conferencing Microphone Array
 VCR10 Remote Control
The VC110 all-in-one unit integrates the camera, the built-in microphone and the codec
into a unit. VC110 all-in-one unit compresses outgoing video and audio data, transmits
Check the list before installation. If you find anything missing, contact your system
administrator.