Configuring Endpoint Settings
143
To configure the audio input device via the web user interface:
1. Click on Setting->Video & Audio.
2. Select the desired value from the pull-down list of Audio Input.
3. Click Confirm to accept the change.
To configure the audio input device via the remote control:
1. Select Menu->Video & Audio->Audio Settings.
2. Select the desired value from the pull-down list of Audio Input.
3. Press the Save soft key to accept the change.
Video packets that exceed the maximum transmission unit (MTU) size for any router or
segment along the network path may be fragmented or dropped. This results in poor
quality video at the receiving device. You can set the maximum MTU size of the video
packets sent by the endpoint. The default value is 1500 bytes. Specify the MTU size used
in calls based on the network bandwidth settings. If the video becomes blocky or
network errors occur, packets may be too large; decrease the MTU. If the network is
burdened with unnecessary overhead; packets may be too small, increase the MTU.
To Next Page
Loading...
