Administrator‘s Guide for Yealink VC110 Video Conferencing Endpoint
144
The MTU parameter on the endpoint is described below.
Specifies the maximum MTU size
(in bytes) of video packets sent
by the endpoint.
Valid Values: Integer from 1000 to
1500
Default: 1500
Note: If you change this
parameter, the endpoint will
reboot to make the change take
effect.
Remote Control
Web User Interface
To configure MTU via the web user interface:
1. Click on Network->Advanced.
2. In the MTU block, enter the desired value in the Video MTU field.
3. Click Confirm to accept the change.
A dialog box pops up to prompt that the settings will take effect after a reboot.
4. Click Confirm to reboot the endpoint immediately.
To configure MTU via the remote control:
1. Select Menu->Advanced (default password: 0000) ->Advanced Network.
To Next Page
Loading...
