Configuring Security Features
177
user to access the web user
interface of the endpoint.
Valid Values: 1-65535
Default: 443
Note: Ensure that the configured
port is not used. If you change
this parameter, the endpoint will
reboot to make the change take
effect.
To configure web server type via the web user interface:
1. Click on Network->Advanced.
2. Select the desired value from the pull-down list of HTTP.
3. Enter the desired HTTP port in the HTTP Port field.
4. Select the desired value from the pull-down list of HTTPS.
5. Enter the desired HTTPS port in the HTTPS Port field.
6. Click Confirm to accept the change.
A dialog box pops up to prompt that the settings will take effect after a reboot.
7. Click Confirm to reboot the endpoint immediately.
To configure web server type via the remote control:
1. Select Menu->Advanced (default password: 0000) ->Advanced Network.
2. Select the desired value from the pull-down list of Web Server Type.
3. Press the Save soft key to accept the change.
To Next Page
Loading...
