Administrator‘s Guide for Yealink VC110 Video Conferencing Endpoint
216
have the same effect as a static image.
Configure the automatic sleep time to be 1 hours or less.
Consider decreasing the monitor‘s sharpness, brightness, and contrast settings if
they are set to their maximum values.
When you do one of the following, the endpoint will reboot:
Reboot endpoint
Reset endpoint
Upgrade firmware
Configure some features need to take effect after a reboot
You can reboot the endpoint in the following ways:
Select Menu->Advanced (default password: 0000) ->Reboot & Reset->Reboot,
and then press .
Log into web user interface and click on Setting->Upgrade->Reboot, and then
click Confirm.
Ensure that the firmware is different from the firmware currently in use.
Ensure that the downloaded firmware applies to the endpoint.
Ensure that the endpoint is powered on normally, and the network is available
during the upgrade process.
When upgrading firmware via the web user interface, ensure that the web user
interface is not refreshed or closed during the upgrade process.
To Next Page
Loading...
