Administrator‘s Guide for Yealink VC110 Video Conferencing Endpoint
36
Do the following:
1. Locate the DVI port on the back of the VC110 all-in-one unit, and connect it to the
DVI port of the cable hub with the supplied DVI cable.
2. Locate the Display1 port of the VC110 all-in-one unit, and connect it to the HDMI
port on the display device with the supplied HDMI cable (Make sure the display
device is powered on).
3. Locate the Internet port on the cable hub, and connect it to the port on the in-line
power switch/hub with the supplied 2m Ethernet cable.
4. (Optional) Locate the Audio In port of the cable hub, and do one of the following:
- Connect it to the Audio Out port of the VCP40 video conferencing phone with
the 7.5m Ethernet cable labeled Audio In.
- Connect it to the Audio Out port of the VCM30 video conferencing microphone
array with the 7.5m Ethernet cable labeled Audio In.
5. (Optional) Locate the VGA output port of the PC, and connect it to the PC port of
cable hub with the supplied VGA cable for sharing content.
6. Locate the DC19V port of the VC110 all-in-one unit, and connect it to an AC power
outlet with the supplied power adapter and power cord.
To Next Page
Loading...
