Yealink VC110 - Page 61

Configuring Network
51
Parameter
DHCP Option
Description
Domain Server
15
Specifies the domain name that client should
use when resolving hostnames via DNS.
Broadcast
Address
28
Specifies the broadcast address in use on the
client's subnet.
Network Time
Protocol
Servers
42
Specifies a list of the NTP servers available to
the client by IP address.
Vendor-Specific
Information
43
Identifies the vendor-specific information.
Vendor Class
Identifier
60
Identifies the vendor type.
TFTP Server
Name
66
Identifies a TFTP server when the 'name' field
in the DHCP header has been used for DHCP
options.
Bootfile Name
67
Identifies a bootfile when the 'file' field in the
DHCP header has been used for DHCP
options.
For more information on DHCP options, refer to
http://www.ietf.org/rfc/rfc2131.txt?number=2131 or
http://www.ietf.org/rfc/rfc2132.txt?number=2132.
To make the endpoint gather network settings via DHCP options, you need to contact
your network administrator to configure the DHCP server properly.
DHCP feature parameters on the endpoint are described below:
Parameter
Description
Configuration Method
DHCP
Enables or disables the endpoint
to obtain network settings from
the DHCP server.
Default: Enabled
Note: If you change this
parameter, the endpoint will
reboot to make the change take
effect.
Remote Control
Web User Interface
Host Name
Configures the host name of the
endpoint.
Default: Blank
Note: When the endpoint
Web User Interface