Yealink VC110 - Page 63

Configuring Network
53
To configure DHCP via the remote control:
1. Select Menu->Advanced (default password: 0000)->LAN Configuration.
2. Check the DHCP checkbox.
3. Press the Save soft key to accept the change.
The display device prompts ―Reboot now?‖.
4. Select OK to reboot the endpoint immediately.
Even though DHCP is enabled, you can manually configure the static DNS address(es).
Parameters of static DNS on the endpoint are described below:
Parameter
Description
Configuration Method
Static DNS
Triggers the static DNS feature to
on or off.
Default: off
Note: If it is set to Off, the endpoint
will use the IPv4 DNS obtained from
DHCP.
If it is set to On, the endpoint will
use manually configured static
IPv4 DNS.
It only works if the value of the ―IP
Config‖ is set to DHCP. If you
change this parameter, the
endpoint will reboot to make the
change take effect.
Remote Control
Web User Interface
Primary DNS
Configures the primary IPv4 DNS
server.
Default: Blank
Note: It only works if the value of
the "Static DNS" is set to On. If
you change this parameter, the
endpoint will reboot to make the
change take effect.
Remote Control
Web User Interface
Secondary DNS
Configures the secondary IPv4
DNS server.
Default: Blank
Note: It only works if the value of
Remote Control
Web User Interface