Configuring Network
65
5. Click Confirm to accept the change.
A dialog box pops up to prompt that the settings will take effect after a reboot.
6. Click OK to reboot the phone.
To configure VLAN via the remote control:
1. Select Menu->Advanced (default password: 0000) ->Advanced Network.
2. In the VLAN block, check the Active checkbox.
3. Enter the VLAN ID in the VID(1-4094) field.
4. Enter the priority value (0-7) in the Priority field.
5. Press the Save soft key to accept the change.
The display device prompts ―Reboot now?‖.
6. Select OK to reboot the endpoint immediately.
The endpoint supports VLAN discovery via DHCP. When the VLAN Discovery method is
set to DHCP, the endpoint will examine the DHCP option for a valid VLAN ID. The
predefined option 132 is used to supply the VLAN ID by default. You can customize the
DHCP option used to request the VLAN ID.
Parameters of VLAN feature on the endpoint are described below.
Enables or disables the DHCP
VLAN discovery feature on the
endpoint.
Default: Enabled
Note: If you change this
parameter, the endpoint will
reboot to make the change take
effect.
Configures the DHCP option from
which the endpoint obtains the
VLAN settings.
You can configure at most five
DHCP options and separate them
by commas.
Valid Values: 128-254
Default: 132
Note: If you change this
parameter, the endpoint will
To Next Page
Loading...
