Yealink VC110 - Page 89

Configuring Network
79
Parameter
Description
Configuration Method
does not use the NAT
feature.
 Manual—the endpoint uses
the manually configured
NAT public address.
 Auto—the endpoint obtains
the NAT public address from
the Yealink-supplied server.
Default: Disabled
NAT Public IP
Address
 Displays the NAT public
address automatically
obtained from the
Yealink-supplied server if
the static NAT is set to Auto.
 Configures the NAT public
address for the endpoint if
the static NAT is set to
Manual.
Remote Control
Web User Interface
NAT_Traversal
Configures the NAT traversal
type. You can configure it for the
SIP account or SIP direct account
separately.
 Disabled
 STUN
 StaticNat
Default: Disabled
Note: Static NAT works only if this
parameter is set to StaticNat.
Web User Interface
To configure static NAT via the web user interface:
1. Click on Network->NAT/Firewall.
2. Select the desired value from the pull-down list of Static NAT.