Yealink W52H

Basic Operations
15
6. Enter the correct values in the IP Address, Subnet Mask, Default Gateway, Primary
DNS and Secondary DNS fields.
7. Press the Save soft key to accept the change.
If you are using an xDSL modem, you can connect your base station to the Internet via
PPPoE mode. The PPPoE port will perform a PPP negotiation to obtain the IP address.
Contact your system administrator for the PPPoE username and password.
To configure PPPoE:
1. Press to enter the main menu.
2. Select Settings->System Settings->Network.
3. Enter the system PIN (default: 0000).
4. Press the Done soft key.
5. Press or to select PPPoE from the IP Address Type field.
6. Enter the correct values in the PPPoE User and PPPoE Password fields.
7. Press the Save soft key to accept the change.
Note
You can view the system status on your handset. Available information of the system
status includes:
 General information—including the IP address, MAC address, firmware version and
RFPI code of the base station.
 Network status—including the IP type, subnet mask, gateway, primary DNS and
secondary DNS.
 Handset status—including the device model, hardware version, firmware version,
product ID, IPUI code and area of the handset.
To check the system status:
1. Press to enter the main menu.
2. Select Settings->Status.
The LCD screen displays the general information.
3. Press or to scroll through the list and view the specific information.
4. Select More …->Network to view the network status.
5. Press or to scroll through the list and view the specific information.
6. Press the Back soft key to return to the previous page.
Using the wrong network parameters may result in inaccessibility of your phone and may
also have an impact on your network performance. For more information about these
parameters, contact your system administrator.