<4. Measurement Procedures> 4-1
IM 80J01A01-01E
4 Measurement Procedures
4.1 Measurement Procedures
Turn the power switch ON, then turn the key switch ON..
CAUTION
Immediately pull out the AC cord from inlet of equipment, when you
notice smoke coming out of the main unit, foul smell, abnormal noise or
any other abnormality.
4.1.1 Exchanging Procedures of Stage Attachment
If you don’t need to exchange stage attachment, go to procedure
shown in 4.1.5 Setting Samples.
Features of each stage attachment are as following.
Chambered Type
※Sealing Blocks
Capable of imaging all wells of microplate
Capable of keeping the temperature,
CO
2
, O
2
concentration and humidity
Note
The range which can be imaged is different between types of stage attachment.
For details, please refer to Technical Information TI 80J01A01-01E (Supported
Sample Vessels).
To Next Page
Loading...
Need help?
General
