<4. Measurement Procedures> 4-39
IM 80J01A01-01E
4.5 Analysis Protocol Setting
Set the viewer layout to “ImageViewer & Chart”.
Pre-acquire the images for analysis setting.
In “Wells” window of “Imaging” window (refer to page 5-25), make
button to status (green) , select a few wells from wells for measure
(selected wells become light blue), and click “PreRec”.
Click “Stop” button to stop measurement.
Selection of negative control well(s) and positive control
well(s) is effectual.
Select a few wells
To Next Page
Loading...
