YOKOGAWA CQ1 - Page 88

4-40 <4. Measurement Procedures>
IM 80J01A01-01E
Select “Application” tab, check to “Execute Analysis”, and click “Load”.
Select “User” tab if you use analysis protocol which is set and saved
previously. Select “Application” tab if you use analysis protocol which is
preloaded in CQ1 Software (Cell Cycle, FISH and so on). Select
“Template” tab if you use basic protocol which is preloaded in CQ1
Software.
Select analysis protocol and click “Load” to load analysis protocol.
(For details, refer to page 5-37)
Check
Select either “User”, “Application”
or ”Template”
Select analysis protocol