YOKOGAWA CQ1 - Imaging Setting

4-36 <4. Measurement Procedures>
IM 80J01A01-01E
4.4 Imaging Setting
If needed, perform following (1) – (3) setting.
(1) Imaging channel setting
“Channels” window of “Imaging” window (refer to page 5-22),
change “Excitation Power” and/or “Exposure” of each imaging
channel.
<In case of using Transmission Illumination with Bright Field/
Phase Contrast>
Push the lever back in case of acquiring phase contrast image.
Pull the lever toward in case of acquiring bright field image.
Select imaging
channel
Change “Excitation
Power” and/or
“Exposure”
Push Back ⇒ Phase contrast
(PH)
Pull toward ⇒ Bright field (BF)