<4. Measurement Procedures> 4-37
IM 80J01A01-01E
(2) Autofocus and 2D/ 3D imaging setting
In “Z Stack” window of “Imaging” window (refer to page 5-28),
change autofocus setting.
Change “Range” and “Slices”. As well, set 1 to “Slices” and 2D
measurement is executed. Set 2 or more and 3D measurement is
executed.
(3) Time-lapse setting
In “Time-lapse Condition” window of “Imaging” window (refer to
page 5-32), change “Interval” and “Duration”. If time-lapse
measurement is not performed, set “1” to “Duration”.
Change “Range”
and “Slices”
Change autofocus
Change “Interval”
and “Duration”
To Next Page
Loading...
