<4. Measurement Procedures> 4-11
IM 80J01A01-01E
4.1.2 Procedures of Filling Water for Humidification
This procedure is only perfomed for controlling environment around
sample. If you don’t need environment control, go to procedure shown
in 4.1.5 Setting Samples.
In case that measurement is running, click “Pause” button to pause.
Click “Sample” tab → “OPEN” Button of CQ1 Software or do long press
(3 seconds) of Door OPEN/CLOSE Button of CQ1 Main Unit to open
the door.
Turn the key switch OFF, then turn the power switch OFF..
To Next Page
Loading...
