5-33
IM 701310-17E
Commands
Command Function Page
:ZOOM:TYPE<x>
Sets the zoom type or queries the current setting. 5-203
:ZOOM:VERTical<x>?
Queries all settings related to the vertical zoom. 5-203
:ZOOM:VERTical<x>:INITialize
Initializes the vertical zoom. 5-203
:ZOOM:VERTical<x>:MAG
Sets the vertical zoom magnification or queries the current setting. 5-203
:ZOOM:VERTical<x>:POSition
Sets the vertical zoom position or queries the current setting. 5-203
:ZOOM:VERTical<x>:TRACe
Sets the trace you wish to display on the vertical zoom screen or queries the
current setting.
5-203
:ZOOM:VLINkage
Turns ON/OFF the vertical link or queries the current setting. 5-203
Common Command Group
*CAL? (CALibrate)
Performs calibration and queries the result. 5-204
*CLS (CLear Status)
Clears the standard event register, extended event register, and error queue. 5-204
*ESE (standard Event Status
Enable register)
Sets the standard event enable register or queries the current setting. 5-204
*ESR? (standard Event Status
Register)
Queries the standard event register and clears the register. 5-204
*IDN? (IDeNtify)
Queries the instrument model. 5-204
*LRN? (LeaRN)
Queries collectively the current settings of the following command groups. 5-205
*OPC (OPeration Complete)
Sets bit 0 (OPC bit) of the standard event register to 1 upon the completion
of the specified overlap command.
5-206
*OPC? (OPeration Complete)
If *OPC? is transmitted and the specified overlap command is completed,
ASCII code 1 is returned.
5-206
*OPT? (OPTion)
Queries the installed options. 5-206
*PSC (Power-on Status Clear)
Sets whether or not to clear the registers below at power on or queries the
current setting. The register is cleared when the value rounded to an integer
is a non-zero value.
5-206
*RST (ReSeT)
Initializes the settings. 5-206
*SRE (Service Request Enable
register)
Sets the service request enable register or queries the current setting. 5-206
*STB? (STatus Byte)
Queries the status byte register. 5-206
*TST?
Performs a self-test and queries the result. The self test involves internal
memory tests.
5-207
*WAI (WAIt)
Holds the subsequent command until the completion of the specified overlap
operation.
5-207
5.1 List of Commands
To Next Page
Loading...
Need help?
General
