Zebra Z Series User Manual

Index
152
79695L-002 Rev. A Z Series
®
/RZ™ Series User Guide 6/6/08
O
odometer, 78
operating conditions, 26
options, 147
ordering replacement parts, 102
ordering ribbon and media, 11
OUT OF MEMORY message, 118
P
PAPER OUT message, 116
parallel port
characteristics of parallel connection, 27
connection and configuration, 29
connector location, 17
setting parallel communications, 84
parity setting, 85
passwords
default, 66
disable, 66
entering, 66
setting password level, 93
PAUSE button
description, 20
FEED and PAUSE self test, 137
PAUSE self test, 133
Peel-Off mode
loading media, 41
media path, 39
print mode use described, 38
selecting, 72
perforated media
described, 34
power
connect to power source, 31
power cord specifications, 32
power switch and connector locations, 17
site selection, 26
Power-On Self Test (POST), 131
print configuration label
CANCEL self test, 132
List Setup command, 79
print darkness setting, 69
print modes
described, 38
load media for different print modes and options,
41
media paths, 39
selecting, 72
print network configuration label, 80
instructions and sample label, 68
print quality
troubleshooting, 119
print server
characteristics of internal wired connection, 27
characteristics of wireless connection, 27
print width setting, 74
printer components, 18
printer diagnostics, 131
printer language modes, 22
printer options, 147
described, 38
load media for different print modes and options,
41
media paths, 39
printer resolution for APL-I, 73
printer settings
backfeed, 90
baud, 84
control prefix, 87
data bits, 85
date, 93
delimiter character, 88
format convert, 92
format prefix, 87
host handshake, 85
idle display, 93
label top, 90
language, 94
left position, 91
maximum label length, 75
media type, 73
network configuration label as baseline, 68
network ID, 86
parallel communications, 84
parity, 85
print darkness, 69
print method, 74
print width, 74
protocol, 86
RFID, 95
saving, 65
serial communications, 84
setting through control panel, 64
time, 93
wired print server, 95
wireless print server, 95
ZPL mode, 88

Zebra Z Series Specifications

General

Print Method	Thermal Transfer or Direct Thermal
Max Print Width	4.09 in./104 mm (depending on model)
Max Print Length	39 in./991 mm (with 203 dpi)
Connectivity	USB, Serial (depending on model)
Supported Media Types	Wristbands
Media Width	1.0 inch (25.4 mm)
Operating Temperature	40°F to 104°F (5°C to 40°C)
Storage Temperature	-40° F/-40° C to 140° F/60° C
Resolution	203 dpi or 300 dpi (depending on model)